JDS Uniphase SmartClass E1, Reference Manual

Page: 21 / 88

Chapter 2 Setup commands
Setup subsystems
SmartClass E1 Tester Remote Control Reference Guide 7
Setup subsystems
The setup subsystems commands are
– s_set
– s_mset
– sarray_set
– s_get
– s_get_g2
– s_mset_default
– s_set_all_default
– s_get_attr
– s_get_all
– s_mget_all
– s_get_allowable
– s_get_valid
– s_get_min_max
– s_file_save
– s_file_restore
– s_file_list
– s_file_delete
– s_list
The following lists examples of the command set for the SETUP subsystem
within the measurement application.
Before you try to change any setups, make sure they are applicable and
changeable.
Changing a setup
This command attempts to change a setup to the value specified.
Command 1
rc s_set setup_name value
Response
SCE:cmsend:ack:s_set
Example
rc s_set E1Bert.Test.Mode MON
When dealing with a string type setup, the value passed in a setup command
must be enclosed in a pair of single quotation marks ('….') or double quotation
marks (“…”).
There are some situations where the setup is a complex structure, for example
a setup array where the setup is presented as a single setup but contains
multiple values. In these cases the format of the command should be as
follows: