Chapter 4
DSL Testing
Connecting to the line
OneExpert DSL User’s Guide
April 2014
22052280, Revision 001
39
b
Select
Data Mode
and then specify
IPoE
,
PPPoE
, or
MultiVLAN
.
None
turns the data
layer off.
c
Select whether to do
Automatic Login
.
d
Select
MAC Address Mode
and specify
factory default or user defined.
e
Specify whether VLANs are used (a check mark indicates they are used).
f
If VLANS are used, specify the following:
–
Enter the
VLAN ID
and
Priority
.
–
Select
IP mode
and then specify the network mode: IPv4, IPv6, or IPv4/IPv6 Dual Stack.
–
Specify the network settings as described in
Press the Back/Cancel navigation key to return to the main screen.
Saving test profiles
After specifying the test settings, you can save them as a test profile.
To save test profiles
1
From the Setup & Tests screen, touch the
Save
button.
2
Enter a name for the profile.
3
Specify whether the profile will be shown on the Home screen
4
Touch
Save
.
The profile is saved.
Connecting to the line
The method used to connect to the line varies depending on the test mode and line configuration.
Connecting to a single twisted pair
To connect to a single twisted pair
1
Using the RJ-45 to telco clips cable, connect the
RJ-45 to bed of nails
test lead to the
DSL
connector on the right panel of the OneExpert DSL.
2
Connect the
RJ-45 to bed of nails
test leads to the desired pair, black to tip(A) and red to
ring(B).
The line is connected.
Summary of Contents for OneExpert DSL
Page 1: ...OneExpert DSL User s Guide...
Page 2: ......
Page 16: ...About this Guide Conventions OneExpert DSL User s Guide xiv 22052280 Rev 000 April 2014...
Page 119: ......
