JDS Uniphase CT-650, Reference Manual

Page: 204 / 248

Appendix B Command Parameter Definitions
Parameter listing
178
CT-650 Command-Line Reference Guide Release 9.4
gain_hit_thres_2 Sets second gain hit threshold from 2 to 10 dB in 1 dB steps.
Default is 3 dB.
gain_hit_thres_3 Sets third gain hit threshold from 2 to 10 dB in 1 dB steps. Default is
6 dB.
high_output_level Upper limit for power of output signal.
injected_error_rate The error rate injected into a tested circuit. Enter in the form
1E-2
to
1E-9
.
interdigit_delay Time between digits, in milliseconds. Applies to DTMF dialing and
multi-frequency only.
log_bit_error_sec Determines if the CT-650 logs bit error seconds. Possible values
are
y
and
n
.
log_file The name of a file that contains logging information for a test. Any
UNIX file name is valid. The file name can include a path.
logfile_update Minutes between logfile updates from 1 to 999. Default is 5 min-
utes.
logon_id ID used to log into the CT-650.
log_frame_error_sec Determines if the CT-650 logs frame errors. Possible values are
y
and
n
.
log_frame_sev_error_sec Determines if the CT-650 logs severe frame errors. Possible values
are
y
and
n
.
log_sev_bit_error_sec Determines if the CT-650 logs severe bit error seconds. Possible
values are
y
and
n
.
loop_code The latching loop code for the selected device. See page 206 for a
list of available loop codes.
loop_down_code A user-defined code used to loop down a circuit.
loop_time The time to transmit the loop code, from 1 to 60 seconds. A value of
less than 5 seconds is unlikely to loop a device, because most
equipment requires a minimum of 5 seconds of transmitted loop
code to operate.
loop_up_code A user-defined code used to loop up a circuit.
Table 8 Command-line parameter definitions (Continued)
Parameter Definition