JDS Uniphase CellAdvisor JD780A Series, User Manual

Page: 558 / 592

JD780A Series Analyzers
558
Using Power Meter
Procedure
1.
Connect a MP-series optical power sensor to the USB Host port of the JD780A series as shown
in Figure 295.
The OPS indicator appears in the system status bar.
2.
Connect the optical cable from the output port of BTS to the power meter.
Figure 295 Optical power sensor connection
JD785A/JD786A
JD788A
Selecting measurement mode
Procedure
1.
Press the MODE hard key.
2.
Select More (1/2) > Power Meter > Optical Power Meter .
The Optical Power Meter screen appears.
Setting measurement parameters
Procedure
1.
Press the MEASURE SETUP hot key.
2.
To select your desired wavelength for testing, do one of the following:
–
To let your instrument detect the wavelength automatically, toggle the Wavelength soft key
and select Auto .
–
To select a wavelength from the wavelength list, complete the following steps:
a. Toggle the Wavelength soft key and select Manual .
b. Press the Stdwave soft key.
The wavelength list box appears.
c. Select the wavelength you want from the list, and then tap the Apply button.
3.
Optional . To edit the wavelength list, complete the following steps:
a. Press the Stored Wavelength soft key.
The Stored Wavelength dialog box appears.
b. Do the following:
–
To add a new wavelength, enter a value between 780 and 1650 in the input box,
and then tap the
Add button.
–
To edit an existing wavelength, highlight a wavelength in the list, enter a new value
between 780 and 1650 in the input box, and then tap the
Edit button.
–
To delete an existing wavelength from the list, highlight a wavelength in the list, and
then tap the
Delete button.
c. Tap the Apply button to save your changes.