JD780A Series Analyzers
Using EV-DO Signal Analyzer
387
measurement result is displayed on the screen as like the following example, Figure 188.
Figure 188
Power vs. time (active slot) measurement with EV-DO signal analyzer
NOTE
You can use the
LIMIT
hot key to analyze your measurements with the user-definable
limit and Pass/Fail indication. See
“Setting limit for power vs. time tests” on page 387 for
more information.
Setting limit for power vs. time tests
Procedure
1.
Press the
LIMIT
hot key.
2.
Press the
PvsT Test Limits
soft key.
3.
Select the test item(s) and set the limit(s):
To set the limit for
Select
Set
Pilot power
Pilot Power
High Limit
Low Limit
Medium access control power
MAC Power
High Limit
Low Limit
Data power during the data period
Data Power
High Limit
Low Limit
On/off power ratio of the pilot and MAC
powers to the data power
On/Off Ratio
Low Limit
4.
Optional
. You can enable alarm sound that goes off if the measurement falls outside of the limit.
Toggle the
Beep
soft key between
On
and
Off
to enable or disable the beep sound.
5.
Optional
. Go to
SAVE/LOAD
> Save
, and then select
Limit
to save the limit settings.
See
“Using save” on page 31 for more information.
Summary of Contents for CellAdvisor JD780A Series
