Assembly Guide of Limited Edition O2+ODAC | Document Revision 1
Pg. 2 of 2
a.
Center pin of power jack is GROUND. Solder center pin (ground wire) to top, right hole of J1.
b.
Sleeve pin of power jack is AC voltage. Solder sleeve pin to bottom hole of J1.
4.
Wire RCA jacks:
a.
White RCA jack is Left audio. Solder center pin to far Left pin of J2
b.
Red RCA jack is Right audio. Solder center pin to far Right pin of J2
c.
Outer sleeve of RCA jacks represent ground. Solder both wires to top, center pin of J2.
d.
Solder enclosure ground wire to center pin of J2.
Figure 2: Wiring of RCA Jacks
5.
Wire 1/4" headphone jack:
a.
See
Figure 3
for pinout of headphone jack (L = White, Red = Right, Black = Ground). Solder wires
of sufficient length to headphone jack to P2.
b.
Solder headphone jack wires to P2. Pinout of P2 as viewed from top to bottom is:
i.
GND
ii.
GND
iii.
LEFT
iv.
RIGHT
Figure 3: Pinout of Headphone Jack. See step 5a
6.
Make sure to orient headphone jack pins as shown. Jack will not fit into case otherwise!
7.
Insert entire assembly into enclosure:
a.
Attach screws of rear plate first
b.
Attach front plate; remember to position enclosure ground wire around bottom right screw!
