P/N 960-100175R_Rev. 6 {EDP #200824}
© 2016, JAPAN CASH MACHINE CO., LTD.
6 - 1
S e c t i o n 6
This section provides Calibration and Performance
Testing instructions for the Taiko
™
Series
Banknote Acceptor (PUB-7/11). This section
contains the following information:
•
Workbench Tool Requirements
•
Software Download Preparation
•
Software Downloading Procedure
•
Calibration Procedure
•
Performance Test Diagnostics
Workbench Tool Requirements
The following workbench tools are required;
•
Taiko Unit (PUB-7/11)
•
JCM Power Supply
•
Taiko Harness A
•
Taiko Harness B
•
VM-450 Harness (for ID-001)
•
VM-450 Unit (for ID-001)
•
KS-070 Reference Paper (
without Bar Code Reader
)
•
KS-088 Reference Paper (
with Bar Code Reader
)
•
PC (Windows
®
2000/XP)
•
Taiko Download Program CD
Software Download Preparation
The following instructions describe how to decom-
press and store a downloaded program onto a PC
for eventual installation into the Taiko™ Banknote
Acceptor:
1. Refer
Figure 6-3 interconnection diagram to
properly connect the power supply, various
cables and wiring Harnesses to the PUB-7/11.
2. Figure 6-1 illustrates the Taiko’s external connec-
tors, DIP Switch Block locations and its initial
Switch settings. To prepare the PUB-7/11 for a
software download, set the DIP Switches as fol-
lows:
–
Set DIP Switch No.1, 7 and 8 to ‘
ON
’
–
Set DIP Switches No.2 through 6 ‘
OFF
’.
3. Supply power to the PUB-7/11. The
Green
Front
Panel Indicator LED will begin flashing approxi-
mately once every second.
Software Downloading Procedure
PC Program Installation
The following PC initialization functions are
required prior to downloading software:
1. Create and name a new PUB Folder on your PC.
2. Extract the PC Program ZIP File and save the
expanded file program contents in the PUB file
Folder just created.
3. Open the Folder and Double Mouse-click on
“Ver.1.20.exe” of the expanded PUB-7/11 PC
Download Program. The
Download Program
Ver.1.20
Screen shown in Figure 6-2 will appear.
4. Mouse-click
on
the
”BROWSE”
Screen Button
a
) and select the desired Software
Program required for installation (i.e., example =
Pll.10801.usa2
).
5. Select an available PC COM Port Number from
the “
Port
” pull-down Menu (Figure 6-2
b
).
6. Confirm that a Baud Rate of 38400 is selected; if
not, set the Baud Rate to 38400 from the “
Baud-
rate
” pull-down Menu (Figure 6-2
c
).
6 CALIBRATION AND TESTING
NOTE: See Figure A-1 on page A-5 to
identify each maintenance part number to
order.
WARNING: Make sure the External
Power Supply is OFF when connecting
the Harnesses to the Taiko™ PUB-7/11.
Failure to do so may cause electrical
shock and/or permanent damage to the
equipment.
Figure 6-1
DIP Switch & Connector Locations
Figure 6-1
DIP Switch & Connector Locations
DIP Switch Block
Interface
Connector
Optional
Connector
Figure 6-2
Figure 6-2
Taiko PC Download Program Screen
a
b
c
d
