JCM Taiko Series, Operation And Maintenance Manual

Page: 40 / 86

P/N 960-100175R_Rev. 6 {EDP #200824} © 2016, JAPAN CASH MACHINE CO., LTD.
4 - 2
Section 4 Taiko™ Series Banknote Acceptor Disassembly/Reassembly
MAG Circuit Board Removal
(PUB-11 Only)
The MAG Circuit Board is mounted in the PUB-11
Unit only. To remove the MAG Circuit Board, pro-
ceed as follows:
1. Remove the two (2) Mounting Screws (Figure 4-4
a
1
& a
2
) retaining the MAG Circuit Board (Figure
4-4 b ) to the Unit.
2. Remove the MAG Circuit Board from the Unit.
3. Remove the single (1) MAG Sensor Relay Har-
ness (Figure 4-4 c ).
Transport Drum Removal
To remove the Transport Drum, proceed as follows:
1. Remove the two (2) Mounting Screws (Figure 4-5
a
1
& a
2
) from the left and right sides of the Unit.
2. Remove the Upper Guide Assembly (Figure 4-6
a ), and remove the left and right Side Covers
(Figure 4-6 b
1
& b
2
) from the Unit.
3. Unplug the two (2) Relay Harnesses (Figure 4-6
c
1
& c
2
) from the Upper Guide Assembly.
4. Remove the Harness Cover (Figure 4-6 d ) from
the right Side Cover and separate the Center
Guide Unit from the Unit.
5. Remove the Transport Drum (Figure 4-7 a ) from
the Unit.
Figure 4-4 Taiko MAG Circuit Board Removal
c
a
1
a
2
b
Figure 4-4 Taiko MAG Circuit Board Removal
Figure 4-5 Taiko Side Mounting Screw
Removal
a
1
a
2
Figure 4-5 Taiko Side Mounting Screw Removal
NOTE: Be careful that the two (2)
Shafts, four (4) Pinch Rollers and
four (4) Springs are not lost when
removing the Upper Center Guide
Assembly.
Figure 4-6 Upper Guide and Side Covers
Removal
c
1
c
2
a
b
1
b
2
d
Figure 4-6 Upper Guide and Side Covers Removal
Figure 4-7 Taiko Transport Drum Removal
a
Figure 4-7 Taiko Transport Drum Removal