JCM GEN5 Series, Operation And Maintenance Manual

Page: 37 / 70

P/N 960-100940R_Rev. A © 2016, JCM American Corporation
4 - 3
Disassembly/Reassembly GEN5™ Series Printer Section 4
Upper Presenter Motor Removal
To remove the Upper Presenter Motor, proceed as
follows:
1. Remove two (2) screws located along the left
side cover (Figure 4-7 a
1
and a
2
).
2. Lift the Cover from the Print Assembly.
3. Remove two gears (Figure 4-8
a
1
and a
2
).
4. Remove one (1) e-clip (Figure 4-8 b ) and the
Platen roller gear (Figure 4-8 c ).
5. Remove four (4) flat head screws holding the left
side (Figure 4-9 d
1
thru d
4
) and the single Pan
Head screw from the inside of the left bracket
(Figure 4-9
e ).
6. Slide the Upper Presenter Motor out of the
Frame.
Upper Platen Roller Removal
To remove the Upper Platen Roller, proceed as

follows:
1. Remove four (4) screws that secure the Cover
(Figure 4-10 a
1
thru a
4
), then remove the Cover.
2. Remove the Platen roller.
Figure 4-7
Left Side Cover Removal
a
1
a
2
Figure 4-8
Remove Gears and E-clip
a
1
a
2
b
c
Figure 4-9
Remove Screws and Motor
e
d
3
d
1
d
2
d
4
Figure 4-10
Upper Platen Roller Cover
a
3
a
4
a
1
a
2