© 2017 JCM American Corporation
1 1
September, 2017
JCM PRINTER BASIC DRIVER
The JCM Printer Basic Driver is used to test and troubleshoot the GEN5
Printer. To test the GEN5 Printer, proceed as follows:
1. Remove power from the GEN5 Printer Unit.
2. Connect the GEN5 Printer to a PC using the Evaluation Harness DB-9
Connector.
3. Reapply power to the GEN5 Printer Unit.
4. From the PC Desktop, double-click on the
JCM Printer Basic Driver
icon.
The
JCM Printer Basic Driver Opening Screen
is displayed (Figure 10).
5. Click to select the Communication
Protocol
- either
RS-232
or
Netplex
Communications (Figure 10
a
).
6. Click to select the COM
Port Number
where the GEN5 Printer is connected
b
).
The
JCM Printer Basic Driver Printer Status Section
is displayed (refer to Figure
NOTE: Printers with USB Firmware will always have RS-232 Communications active.
a
b
Figure 10
JCM Printer Basic Driver Opening Screen
