JCM A-66, Manual

Page: 10 / 14

Optipay® CC JCM Training Overview JCM Training Overview December, 2006
Part No. 960-000153R_ Rev. A © 2006, JCM American, Corporation
1 0 1 9
Lecture Notes
Lecture Notes
MAINTENANCE & CLEANING
P
REVENTIVE
M
AINTENANCE
Liquids, dust build-up, and other small foreign materials that inadvertently
enter the Coin Changer can interfere with sensor measurements, cause coin
jams, or affect the accepted/rejected coin rate.
Clean the Coin Validator Unit from time to time with a damp cloth.
Use lukewarm water containing a mild dish cleaning liquid detergent.
Use canned/compressed air to blow out the unit after it has been cleaned and
wiped clean.
C
LEANING
P
ROCEDURE
Perform the following steps to clean an A-66 Coin Changer:
1. Remove AC Power to the Vending Machine.
2. Press up on the Locking Catch Lever and open the Coin Validator's Fly Deck.
3. Wipe the coin runway clean inside the coin validation area.
4. Use compressed air to blow away any remaining particles.
5. Close the Coin Validator's Fly Deck and gently press in on the White dot located
beneath the 'Close' arrow until the metal spring engages behind the lever and a
‘click’ is heard.
6. Reconnect AC power to the Vending Machine.
NOTE: WHEN CLEANING THE COIN CHANGER, DO NOT USE SOLVENTS OF
ANY KIND, OR SCOURING AGENTS WHICH CAN HARM THE PLASTIC
SURFACES OF THE UNIT!
NOTE: Under no circumstances should the cloth be wet enough to allow excess
fluid to run into the unit, which could possibly cause internal circuit board damage.
P
ALM
A66US (C
ONTINUED
)
4. Select the ‘Operating Modes’ Screen Button to obtain the screen depicted in
Figure 20. Select the desired functions and then click on ‘Send’ to program the
A-66 Coin Changer. Selecting ‘Cancel’ will return you to the ‘Settings’ menu.
A description of each function is provided in the Operating Modes Menu are as
follows:
Inventory
check box functions:
• Blocked
—
Inventory Keypad is disabled
• Enabled by Machine Control
—
Inventory Keypad can be enabled by
the Vending Machine
• Enabled
—
Inventory Keypad is enabled
Pay-out security stock allowed: Enables the machine to pay out the
entire contents of the coin tubes.
Float up function on: Enable to allow float levels in the coin tubes.
Float values may be set on the coin settings page.
Tube counter with security stock: allows for including security
stock levels when transmitting the coin tube levels to the VMC.
Figure 20 A-66US Ops Mode Screen
a
Figure 19 A-66US Sub-Menu
a