3.-
Remove the
existing batteries
jcm
technologies
EC declaration of conformity
JCM TECHNOLOGIES, S.A., declares herewith that this product is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC and complies
with the fundamental requirements of the 2004/108/EC Directive on electromagnetic com-
patibility and 2006/95/EC on low voltage, insofar as the product is used correctly.
See web www.jcm-tech.com
UM_3200234_EN_Rev00.pdf
Installation
4.-
Insert the supplied
rechargeable batteries
in the correct position.
A
B
2.-
Disconnect the
battery connector from
the board.
1.-
Remove the
Radioband/TBX cover
with a screwdriver.
5.-
Connect the battery
connector to the
RBAND SPC male
connector (A), and the
RBAND SPC female
connector to the
electronic board (B).
6.-
Cover the RADIOBAND/TBX with the RBAND SPC.
