UM_3200348_BASELEC500_2ID_Rev01
Page 7/8
Configuration
OPERATION MODE CONFIGURATION
The equipment can operate with proximity system or Free system, but not both at once. Select the switch position for the desired
performance.
SWITCH
OFF
ON
1
Proximity mode BUS-L (EVOPROX)
Hands free mode with FREE 15R
Note: A wrong selection of the proximity device that is being used will cause an inoperation or a power consumption increase
during the emergency mode.
RECEIVER SETTINGS
It can be operate with Soft-Assistant to manage code memory of the receiver.
SETTING TIME RELAY ACTIVATION
Press the programming button for 1s, the LED turns on and the equipment beeps. Hold down the programming button and the
equipment enters in a cyclical sequence of four beeps. Each of these signals indicates a preset time relay activation. Stop
pressing the button beeps when the desired time appears.
Acoustic signal
Time relay activation
1
3 seconds
2
5 seconds
3
7,5 seconds
4
9,5 seconds
Operation
NORMAL OPERATION
The R1 light indicator is activated each 5 seconds showing the correct power supply of the equipment.
When the equipment receives a code it checks automatically if it is in the memory, and it actives the corresponding relay.
If the battery is not connected or it is not working properly, the receiver will make three acoustic signs each time it is activated by
the transmitter.
EMERGENCY MODE
If the power supply falls down and the battery is connected, the system will switch to emergency mode.
-
If it is working with the MOTION system, the EVOPROX will be activated every 8 seconds out of 22. During this period, the
activation will be ready only one second
-
If it is working with the FREE system, the FREE 15R will be available 1 second out of 10.
Programmation
MANUAL PROGRAMMING
Press the receiver programming button for 1 second, the light indicator will turn on and an acoustic signal will be heard. The
receiver will enter standard programming. Send the code and the channel to be programmed by pressing the corresponding button of
the transmitter.
Every time a transmitter is programmed, the receiver will issue an acoustic signal for 0.5 sec. After 10 seconds without
programming, or pressing the programming button, or the first two buttons of the transmitter (depending on the programming mode)
the receiver will exit programming mode issuing two acoustic signals of 1 sec. If upon programming a transmitter the receiver
memory is full, it will issue 7 acoustic signals of 0.5 sec. and exit programming.
TOTAL RESET
In programming mode, the programming button is held down and the “MR” reset jumper is bridged for 10 seconds. The receiver will
issue 10 short acoustic warning signals followed by others at a faster pace to indicate that the operation has been successful. The
receiver is now in programming mode. The programming light indicator will also follow the sound indications issuing intermittent
lights.
After 10 seconds without programming or pressing the programming button, the receiver will exit programming mode, issuing two
acoustic signals of 1 sec.
