JCM GLOBAL VEGA Series, Operation And Maintenance Manual

Page: 44 / 114

P/N 960-100189R_Rev. 4 {EDP #148850} © 2016, JAPAN CASH MACHINE CO., LTD.
4 - 2
Section 4 VEGA™ Series Banknote Validator Disassembly/Reassembly
8. While lifting up on the Upper Transport Unit
(Figure 4-4 a ), gently widen one side of the
Lower Transport Unit hinge area (Figure 4-4 b ),
and separate the Upper Transport Unit from the
Lower Transport Unit.
9. Pull the Front Bezel (Figure 4-5 a ) forward and
off the Upper Transport Unit (Figure 4-5 b ).
10. Remove the two (2) Flap Positioning Springs
(Figure 4-6 a
1
& a
2
) from the side of the Upper
Transport Unit (Figure 4-6 b ).
11. Remove the single E-Ring (Figure 4-7 a ) from the
end of the Flap Axis (Figure 4-7 b ).
12. Slide the Flap Axis containing the mounted left
Flap Lever (Figure 4-7 c ) and remove the right
(Figure 4-7 d ) and left Flap Lever from the Flap
Axis end.
13. Carefully remove the Flap 1 (Figure 4-7 e ) and
Flap 2 (Figure 4-7 f ) up and off the Upper Trans-
port Unit.
Figure 4-3
Upper Assembly Separation (Part
1)
a
b
1
b
2
c
Figure 4-3
Upper Assembly Separation (Part 1)
Figure 4-4
Upper Assembly Separation (Part
2)
b
a
Figure 4-4
Upper Assembly Separation (Part 2)
Figure 4-5
Front Bezel Removal
b
a
Figure 4-5
Front Bezel Removal
Figure 4-6
Flap Positioning Spring Removal
b
a
2
a
1
Figure 4-6
Flap Positioning Spring Removal
Figure 4-7
Shaft and Flap #1 & #2 Removal
a
b
c
d
e
f
Figure 4-7
Shaft and Flap #1 & #2 Removal
NOTE: When re-attaching the Right Flap
Lever, ensure that the retaining pin portion
of the left Flap Lever (Figure 4-8
a )
securely fits into the Flap 1 mating hole
(Figure 4-8
b ) and the corresponding pin of
the right Flap Lever (Figure 4-8 c ) fits into
Flap 2 mating hole (Figure 4-8 d ).