JCM GLOBAL UBA Pro RT Series, Operation And Maintenance Manual

Page: 85 / 196

P/N 960-000213R_Rev.A © 2020, JAPAN CASH MACHINE CO., LTD.
4 - 2 1
Disassembly/Reassembly UBA Pro RT/RQ™ Series Banknote Recycler Section 4
Rubber Pulley and Drive Roller
Removal (Drum 1 Side)
To remove the Rubber Pulley and Drive Roller
from the Drum 1 Side, proceed as follows:
1. Remove the two (2) E-rings (Figure 4-105 a
1
&
a
2
) and the two (2) Bearings (Figure 4-105 b
1
&
b
2
).
2. Remove the three (3) E-rings (Figure 4-106 a
1
through a
3
) and the single (1) Parallel Pin (Figure
4-106 b ).
3. Remove the two (2) Rubber Pulleys (Figure 4-
106 c
1
& c
2
) and the single (1) Drive Roller (Fig-
ure 4-106 d ).
Solenoid Removal
To remove the Solenoid from the Drum 1 Side,
proceed as follows:
1. Rotate the Handle (Figure 4-107 a ) all the way in
the direction indicated by the Arrow.
2. Pull out the two (2) Tapes (Figure 4-108 a
1
& a
2
).
3. Peel off the Clip Sticker (Figure 4-108 b ).
4. Remove the two (2) Clips (Figure 4-109 a
1
& a
2
).
5. Peel off and separate Tapes (Figure 4-110 a
1
through a
4
).
6. Remove the single (1) E-ring (Figure 4-111 a ),
the single (1) Handle (Figure 4-111 b ), the single
(1) Parallel Pin (Figure 4-111 c ), and the single
(1) Bearing (Figure 4-111 d ).
Figure 4-105 Rubber
Figure 4-105 Rubber Pulley and Dive Roller
Removal (Drum 1 Side) 1
a
1
a
2
b
1
b
2
Drum 1 Side
Figure 4-106 Rubber
Figure 4-106 Rubber Pulley and Dive Roller
Removal (Drum 1 Side) 2
a
1
a
2
b
a
3
d
c
1
c
2
Figure 4-107 Sole-
Figure 4-107 Solenoid Removal 1
a
Drum 1 Side
Figure 4-108 Sole-
Figure 4-108 Solenoid Removal 2
a
1
a
2
b
Figure 4-109 Sole-
Figure 4-109 Solenoid Removal 3
a
1
a
2
Figure 4-110 Sole-
Figure 4-110 Solenoid Removal 4
a
1
a
3
a
2
a
4
Figure 4-111 Sole-
Figure 4-111 Solenoid Removal 5
a
b
c
d