JCM GLOBAL UBA Pro RT Series, Operation And Maintenance Manual

Page: 72 / 196

P/N 960-000213R_Rev.A © 2020, JAPAN CASH MACHINE CO., LTD.
4 - 8
Section 4 UBA Pro RT/RQ™ Series Banknote Recycler Disassembly/Reassembly
3. Pick up the Shaft Assy. (Figure 4-33 a ) as illus-
trated by the Arrow
①
, and then remove it in the
direction indicated by the Arrow
②
,
4. Remove the six (6) Screws (Figure 4-34 a
1
through a
6
) to remove the Pulley Cover (Figure
4-34 b ).
5. Remove the Gear Assy. (Figure 4-35 a ).
6. Remove the two (2) Bearings (Figure 4-35 b
1
&
b
2
) from the TR Worm Gear (Twin) (Figure 4-35
c ).
TR Worm Wheel (Twin) Removal
To remove the TR Worm Wheel (Twin) out of the
RT Frame Unit, proceed as follows:
1. Remove the Wheel Assy. (Figure 4-36 a ).
2. Remove the two (2) Bearings (Figure 4-36 b
1
&
b
2
) from the TR Worm Wheel (Twin) (Figure 4-
36 c ).
TR Motor Harness Assy. Removal
To remove the TR Motor Harness Assy., proceed
as follows:
1. Remove the Motor Assy. (Figure 4-37 a ).
2. Remove the two (2) Screws (Figure 4-38 a
1
&
a
2
).
3. Remove the Detection Plate (Figure 4-38 b ), the
Motor Plate (Figure 4-38 c ) and the Pinion Gear
(Figure 4-38 d ) from the TR Motor Harness Assy.
(Figure 4-38 e ).
Figure 4-33 TR Worm Gear (Twin) Removal
Figure 4-33 TR Worm Gear (Twin) Removal
(RT Frame Unit) 3
①
②
a
Figure 4-34 TR Worm Gear (Twin) Removal
Figure 4-34 TR Worm Gear (Twin) Removal
(RT Frame Unit) 4
b
a
1
a
2
a
3
a
5
a
4
a
6
Figure 4-35 TR Worm Gear (Twin) Removal
Figure 4-35 TR Worm Gear (Twin) Removal
(RT Frame Unit) 5
a
b
1
b
2
c
Figure 4-36 TR Worm Wheel (Twin) Removal
Figure 4-36 TR Worm Wheel (Twin) Removal
(RT Frame Unit)
a
b
1
b
2
c
Figure 4-37 TR Motor Harness Assy. Removal
Figure 4-37 TR Motor Harness Assy. Removal 1
a
Brown
Red
NOTE: For the reassembly, ensure that the
Motor Assy. is installed considering the
positions of the “Brown” and “Red” Cables.
Figure 4-38 TR Motor Harness Assy. Removal
Figure 4-38 TR Motor Harness Assy. Removal 2
e
b
a
1
a
2
c
d