JCM GLOBAL UBA Pro RT Series, Operation And Maintenance Manual

Page: 71 / 196

P/N 960-000213R_Rev.A © 2020, JAPAN CASH MACHINE CO., LTD.
4 - 7
Disassembly/Reassembly UBA Pro RT/RQ™ Series Banknote Recycler Section 4
3. Separate the Rear Transport Unit (Figure 4-27 a )
as illustrated.
Flap Motor Harness Assy. Removal
To remove the Flap Motor Harness Assy. out of the
RT Frame Unit, proceed as follows:
1. Remove the five (5) Screws (Figure 4-28 a
1
through a
5
) to remove the Gear Cover (Figure 4-
28 b ).
2. Remove the Worm Wheel (Figure 4-29 a ) and the
Worm Gear (Figure 4-29 b ).
3. Remove the Flap Motor Harness Assy. (Figure 4-
30 a ).
TR Worm Gear (Twin) Removal
To remove the TR Worm Gear (Twin) out of the RT
Frame Unit, proceed as follows:
1. Remove the single (1) E-ring (Figure 4-31 a ), the
single (1) Gear (Figure 4-31 b ), the single (1)
Parallel Pin (Figure 4-31 c ) and the single (1)
Rolled bushing (Figure 4-31 d ).
2. Remove the single (1) E-ring (Figure 4-32 a ) and
the single (1) Bearing (Figure 4-32 b ).
Figure 4-27 Rear Transport Unit Removal (RT
Figure 4-27 Rear Transport Unit Removal
(RT Frame Unit) 2
a
Figure 4-28 Flap Motor Harness Assy.
Figure 4-28 Flap Motor Harness Assy. Removal
(RT Frame Unit) 1
b
a
1
a
2
a
3
a
4
a
5
Figure 4-29 Flap Motor Harness Assy.
Figure 4-29 Flap Motor Harness Assy. Removal
(RT Frame Unit) 2
b
a
Figure 4-30 Flap Motor Harness Assy.
Figure 4-30 Flap Motor Harness Assy. Removal
(RT Frame Unit) 3
a
Figure 4-31 TR Worm Gear (Twin) Removal
Figure 4-31 TR Worm Gear (Twin) Removal
(RT Frame Unit) 1
a
b
c
d
Figure 4-32 TR Worm Gear (Twin) Removal
Figure 4-32 TR Worm Gear (Twin) Removal
(RT Frame Unit) 2
a
b