Positec Australia Pty Limited
Unit 15, 23 Narabang Way, Belrose 2085 NSW Australia
www.jcb-tools.com
Customer Helpline 1300 889 028
WORKING HINTS FOR YOUR DRILL
1. Drilling masonry and concrete Push drill /impact action selector switch the left
position (as viewed from the front of the drill). Tungsten carbide drill bits should
always be used for drilling masonry, concrete etc with a high speed.
2. Drilling steel Push drill /impact action selector switch the right position (as
viewed from the front of the drill). HSS drill bits should always be used for drilling
steel with a lower speed.
3. Screw driving Push drill /impact action selector switch the right position (as
viewed from the front of the drill). Use a low speed to drive in or remove screws.
4. Pilot holes When drilling a large hole in tough material (i.e. steel), we
recommend drilling a small pilot hole first before using a large drill bit.
5. Drilling tiles Push drill /impact action selector switch the right position (as
viewed from the front of the drill) to drill the tile. When tile has been penetrated,
switch over to “ Impact “position.
6. Cool the motor If your power tool becomes too hot, set the speed to maximum
and run no load for 2-3 minutes to cool the motor.
MAINTENANCE
1. Your power tool requires no additional lubrication or maintenance. There are no
user serviceable parts in your power tool.
2. Never use water or chemical cleaners to clean your power tool. Wipe clean with
a dry cloth.
3. Always store your power tool in a dry place.
4. Keep the motor ventilation slots clean.
5. If the supply cord is damaged, it must be replaced by the qualified persons in
order to avoid a hazard.
TROUBLESHOOTING
1. If your drill will not operate, check the power at the mains plug.
2. If the drill is not operation properly, check the drill bit for sharpness, replace drill
bit if worn. Check that the drill is set to forward rotation for normal use.
3. If a fault can not be rectified return the drill to an qualified person for repair.