SO53 3LE
Customer Helpline
0845 600 5526
SO53 3LE
Customer Helpline
0845 600 5526
SO53 3LE
Customer Helpline
0845 600 5526
Depress the switch trigger to start
the tool. Move the drill bit into the
workpiece, applying only enough
pressure to keep the bit rotating. Do
not force or apply side pressure to
elongate a hole.
tungsten carbide drill bits
should always be used for
concrete and masonry. when
drilling in metal, only use HSS drill
bits in good condition. always use
a magnetic bit holder (not
included) when using short
screwdriver bits. when screw-
driving, apply a small quantity of
liquid soap or similar to the screw
threads to ease insertion.
10. DISPOSaL Of an
ExHauStED BattERy
PaCK
To preserve natural
resources, please recycle or
dispose of the battery pack
properly. This battery pack contains
Lithium batteries. Consult your local
waste authority for information
regarding available recycling and/or
disposal options. Discharge your
battery pack by operating your drill,
then remove the battery pack from
the drill housing and cover the
battery pack connections with
heavy-duty adhesive tape to prevent
short circuit and energy discharge.
Do not attempt to open or remove
any of the components.
11. OvERLOaD
PROtECtIOn
When overloaded, the motor comes
to a stop. Relieve the load on the
machine immediately and allow
cooling for approx. 30 seconds at
the highest no-load speed.
12. tEMPERatuRE
DEPEnDEnt OvERLOaD
PROtECtIOn
When using as intended the power
tool cannot be subject to overload.
When the load is too high or the
allowable battery temperature of
75°C is exceeded, the electronic
control switches off the power
tool until the temperature is in the
optimum temperature range again.
13. PROtECtIOn agaInSt
DEEP DISCHaRgIng
The Li-ion battery is protected
against deep discharging by the
“Discharging Protection System”.
When the battery is empty, the
machine is switched off by means
of a protective circuit: When this
occurs your tool will not switch on.
Remove and recharge the battery
pack.
