6
JCB-20USB
Instruction & User Manual
OPERATING INSTRUCTIONS
Intended Use
This USB power adaptor is intended for use
only with a compatible JCB 20V lithium-ion
battery pack.
The component must not be modified or used
for any other purposes than the ones described
in these instructions.
Battery
Make sure the power button (3) on the top
of the USB power adaptor is not pressed in
when inserting or removing the battery.
NOTE
m
Do not use excessive force when
inserting the JCB battery in the USB
power adaptor.
An incorrectly connected
battery can damage the battery terminals
or the battery socket on the USB power
adaptor.
m
Connect the battery to the battery socket of
the USB power adaptor so that it clicks into
place.
m
Use the button on the battery to check the
charging status; 4 red LEDs indicates fully
charged, where 1 indicates low battery
status.
m
Place the USB power adaptor on a level
and stable surface. Connect your USB
device with a suitable cable to one of the
USB ports on the back of the USB power
adaptor.
m
Press the power button (3) on the top of
the USB power adaptor once to commence
power output to the USB ports.
m
To stop the power output to the USB ports
simply remove the USB supply cable from
the USB port.
LED Torch Operation
m
Press the power button (3) on the top
of the USB power adaptor until the red
indicator starts flashing.
m
When the red indicator is constantly
illuminated, press the power button (3)
again and the LED torch will power on.
m
Press the powe button (3) again to power
down the LED torch.
The red indicator (4) will initially flash during
the power up stage. Upon supplying power
to the two USB ports the red indicator will
illuminate constantly.
NOTE
The USB power adaptor will detect the
cable disconnection and automatically power
down. The red indicator will also extinguish
to confirm the power has been disconnect-
ed.
NOTE
If you press the power button (3) again
while the red indicator remains illuminated,
the LED Torch will power on, but if the red
indicator is not illuminated the LED torch
will not power on until the red indicator
is illuminated and the power button (3) is
pressed again.
NOTE