18
JCB-20BLCD
Instruction & User Manual
m
Use the high speed mode for drilling small
holes.
Maintenance
Switch off the power tool and disconnect
the power (remove battery/unplug) before
cleaning and maintenance. This helps avoid
the risk of electric shocks and accidental
starting.
WARNING!
m
Wipe the power tool with a dry or damp
cloth.
Do not use a wet cloth.
Do not
use detergent that contains solvent
or corrosive, abrasive additives.
This
risks damaging the surfaces of the tool.
m
Clear the power tool vents and the chuck
mount of dust and dirt after each use.
Do not clean ventilation holes by
inserting sharp objects in them, such
as screwdrivers and other similar
objects.
m
Stubborn contamination in areas hard to
access can be removed with compressed air
(max 3. bar).
m
Regularly check all fasteners, screws and
bolts to make sure that they are tight.
Tighten any loose screws immediately or
serious injury could occur.
Never open the power tool. The power
tool has no internal parts that the user can
service or repair. Never try to repair the
power tool yourself. Take to an authorised
service centre.
WARNING!
Transport and Storage
m
If the power tool will remain unused for any
length of time, it should be stored in the
original packaging.
m
Store the power tool and battery in a dry,
frost-free, well ventilated place.
m
Keep all tools out of the reach of children.
m
Always switch off the power tool and
disconnect it from the power supply
(remove the battery/unplug the power
cord) before transport.
m
Always carry the power tool using the
purpose-designed handle.
m
Ensure that the tool is not at risk of tipping
over or exposed to excessive vibration and
shocks during transport, especially if the
power tool will be transported by car or
other vehicle.
Operating temperature: 0-40 °C
Storage temperature: 20-60 °C
NOTE
