16
JCB-18BLDD
Instruction & User Manual
m
Press the bit firmly against the screw and
drive in the screw.
m
Once the screw is sufficiently tightened,
release the power switch
before
you stop
pressing in the screw, otherwise you can
damage the screw or screw head. The
bit or tool can be damaged if you do not
release the power switch immediately.
To unscrew/loosen screws:
m
Set the rotation selector to anticlockwise
rotation.
m
Place the bit into the screw head in line with
the screw. Otherwise the screw can be
damaged.
m
Press the bit firmly against the screw and
loosen the screw.
Speed Control
Only use the speed control switch when the
tool is stopped and the chuck is not rotating.
Otherwise the tool can be damaged.
WARNING!
m
Move the speed control switch away from
the chuck to position 1 for low speed (0 to
350rpm).
m
Use the low speed mode for screw driving
and for drilling holes with a large diameter.
m
Move the speed control forwards towards
the chuck to position 2 for high speed (0 to
1200 rpm).
m
Use the high speed mode for drilling small
holes.
Maintenance
Switch off the tool and disconnect the power
(remove battery/unplug) before cleaning and
maintenance. This helps avoid the risk of
electric shocks and accidental starting.
WARNING!
m
Wipe the tool with a dry or damp cloth.
Do not use a wet cloth.
Do not use
detergent that contains solvent or
corrosive, abrasive additives.
This risks
damaging the surfaces of the tool.
m
Clear the tool vents and the accessory
mount of dust and dirt after each use.
Do not clean ventilation holes by
inserting sharp objects in them, such
as screwdrivers and other similar
objects.
m
Stubborn contamination in areas hard to
access can be removed with compressed air
(max 3. bar).
m
Regularly check all fasteners, screws and
bolts to make sure that they are tight.
Tighten any loose screws immediately or
serious injury could occur.
Never open the tool. The tool has no
internal parts that the user can service or
repair. Never try to repair the tool yourself.
Take to an authorised service centre.
WARNING!
Transport and Storage
m
If the tool will remain unused for any length
of time, it should be stored in the original
packaging.
m
Store the tool in a dry, frost-free, well
ventilated place with a temperature of no
more than 40°C.
