14
JCB-12ID
Instruction & User Manual
OPERATING INSTRUCTIONS
Intended Use
This impact driver is intended for percussive
tightening and loosening of nuts, screws and
other fixings.
The tool must not be modified or used for
any other purposes than the ones described in
these instructions.
Battery
Make sure the ON/OFF Trigger (4) is not
operated when inserting or removing the
battery. Use only JCB batteries: JCB-12-
15LI, JCB-12-20LI, JCB-12-30LI, JCB-12-
40LI.
NOTE
m
Do not use excessive force when
inserting the JCB battery in the
power tool.
An incorrectly connected
battery can damage the battery terminals or
the battery socket on the power tool.
Charging The Battery
After charging for the first time, ensure the
battery is completely discharged before
placing on charge again. Repeat this charging
and discharging cycle 4 to 5 times to ensure
battery is correctly conditioned.
WARNING!
m
Place the battery charger on a level and
table surface. Connect the battery pack to
the charger so that it clicks in to place.
m
Plug the charger into a suitable power
supply. Note: ensure the voltage on the
charger rating label matches the power
supply voltage.
m
Refer to the Battery Charge Level table
below for battery charger status as indicated
by LED lights.
m
Unplug the charger from the power point
prior to removing the battery from the
charger.
Battery Charge Level
Red
LED
Green
LED
Battery Charge Status
Charger is connected to
mains power
Connected battery is
charging
Connected battery is fully
charged
Connected battery has a
charging fault
Charger is outside correct
operating temperature
range (<0˚C / >40˚C)
If the LEDs on the charger do not illuminate
when charging:
m
Check that mains plug is properly connected
to the power supply and the supply is
switched on.
m
Check that the battery is correctly inserted
in the charger.
Connecting the battery
m
Connect the battery to the battery socket
on the power tool so that it clicks into place.
Removing the battery
m
Press the battery release button (6) and
remove the battery from the power tool.