SETTING UP
ADJUSTING TRACKS AND TRAYS
1) Pull out tray and lift tray
at a 45
°
angle to remove
tray from the track.
THANK YOU FOR CHOOSING CHD SERIES DRYING CABINETS
The CHD Series Electronic Dry Cabinet protects your lenses, photographic and
optical equipment, mobile electronics, leather products and other valuable
accessories form excessive moisture.
CHD Series Electronic Dry Cabinet uses the “Cold-Chip” technology to regulate the
interior’s relative humidity. It helps to prevent fungus and corrosion from damaging
your equipment.
The Cold-Chip colds a metal surface to induce condensation of air moisture from
gaseous state to liquid state. The water collected will be evaporated through the
vent and renders the enclosed environment dry. The cabinet operates silently
without any fan or compressor. The tempered glass door and magnetic rubber seal
provide extra protection against dust, prolonging the lifespan of your gear.
◆
Place cabinet in a well ventilated area to facilitate evaporation to take place.
◆
Leave a gap of at least 5cm against wall for evaporation.
◆
Make sure that the power cable is plugged in securely before turning on power.
◆
Keep this product away from direct sunlight, high temperature and windy environment.
2) Lift the track upwards at
a 90
°
angle to remove
track for the cabinet.
3) To put back the tracks into cabinet, place track at the desired level and
insert it into the holes with the roller track facing upwards and then turn
downwards to lock the track in place.
Place tray at 45
°
angle at the front of the track and push gently to put tray
back into the track.
CONTROL SETTING
CHD Series (50L to 1200L)
◆
Uses a digital controlled LED hygrometer
After switching on power, the hygrometer will be lighted up and a red LED light will be
lighted on the dehumidifier to represent power supply.
◆
“S” Button to set humidity level. Press “S” button once and the % reading on display
will start to flick
◆
Adjust the humidity level by pressing “UP” or “Down” button until required
humidity% is shown
◆
Pressing “S” button again to confirm setting
◆
Green light - means the dehumidifier is
functioning to your setting humidity
◆
Red light– means the cabinet is already
connecting to the power supply
* When dehumidifier is functioning to your
setting humidity, Green and Red light will
lighting at the same time.
* When dehumidifier reached to your setting
humidity, Green light will turn off
Dehumidifier
