TROUBLESHOOTING
NO SOUND
q$MRTQDSGD "#"@C@OSNQHRETKKX
inserted into the AC outlet and the
power connection input on the
transmitter.
q$MRTQDXNTUDHMRDQSDCSGDA@SSDQHDR
correctly.
q$MRTQDSGDGD@COGNMDR@QDRVHSBGDC
ON.
q'D@COGNMDA@SSDQXBG@QFDKDUDK
may be too low, fully recharge the
batteries.
q$MRTQDSG@SSGDBNMMDBSDC@TCHN
source device is switched ON and
is playing.
q3GDUNKTLDNESGDGD@COGNMDRL@X
be too low. Increase the volume of
the audio source.
DISTORTION
q$MRTQDSGDUNKTLDKDUDKNESGD
headphones is set to an appropriate
level.
q(ESGDGD@COGNMDR@QDSNNE@QEQNLSGD
transmitter, move them closer.
q(ESGD@TCHNRHFM@KHMOTSKDUDKHRSNN
low. Increase the volume of the audio
source.
INTERFERENCE
q(EXNTDMBNTMSDQHMEDQDM -
systems,
Bluetooth
devices or other
2.4GHz systems we recommend
moving the transmitter away from the
other device / system.
q8NTQ)!+61RB@MRENQ@EQDD
frequency slot each time you plug
in the power cable into the DC jack
of the transmitter. If an additional
2.4GHz source appears after you
initially set up your WR2.4, we
recommend that you unplug the
power cable for 1 minute and
then re-connect it to allow a new
frequency scan.
TECHNICAL
SPECIFICATIONS
Transmission Mode:
UHF Stereo
Carrier Frequency:
2.4GHz Digital
Operation Voltage:
Transmitter:
DC 5V 550mA
Headphone:
W RHYD
rechargeable NiMH batteries
(included)
Frequency Response:
18Hz- 20kHz
S/N Ratio:
75dB
Operating Distance:
typically 20
meter/ 65 ft
HARMAN International Industries, Incorporated
8500 Balboa Boulevard, Northridge, CA 91329 USA
© 2013 HARMAN International Industries, Incorporated. All rights reserved. JBL is a
trademark of HARMAN International Industries, Incorporated, registered in the United
States and/or other countries.
The
Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth SIG,
Inc., and any use of such marks by HARMAN International Industries, Incorporated, is
under license. Other trademarks and trade names are those of their respective owners.
All Rights Reserved.
Features, specifications and appearance are subject to change
without notice.
Part No. JBLP5356 Rev: A
www.jbl.com
FCC STATEMENT
NOTE:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference with one or more of
the following measures:
q1D@CITRSNQCHRS@MBDSGDQDBDHUHMF@MSDMM@
q(MBQD@RDSGDRDO@Q@SHNMADSVDDMSGDDPTHOLDMS@MCQDBDHUDQ
q"NMMDBSSGDDPTHOLDMSHMSN@MNTSKDSNM@BHQBTHSCHEEDQDMSEQNLSG@SSN
which the receiver is connected.
q"NMRTKSSGDCD@KDQNQ@MDWODQHDMBDCQ@CHN35SDBGMHBH@MENQGDKO
Shielded cables and I/0 cords must be used or this equipment. Changes
NQLNCHjB@SHNMRMNSDWOKHBHSKXOQNUDCHMVQHSHMFAX)!+L@XL@JDSGDTRDQR
authority to operate this equipment void. This device complies with Part
15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference. and (2) this device must
accept any interference.
JBL hereby declares that the WR2.4 headphones comply with the essential requirements
and other relevant provisions of Directive 1999/5/EC. To order your free copy of our
Declaration of Conformity, please visit http://www.jbl.com. or contact [email protected].
