47
VTX A
8
| Rigging Manual
STEPS:
• With the VT completely secured, lower the array until the front wheels of the VT touch the ground. The array should start to roll
backwards slightly and, as the array is lowered, the inter-enclosure angles of the bottom four boxes will close to the 10-degree
position.
• Once the lowest four boxes are entirely collapsed and the gap between cabinets four and five from the bottom is closed, set
the angle selection QRPs on the bottom four A8 cabinets to the 10-degree STORAGE position.
• Close all eight RED Locking latches.
• Remove the rear QRPs joining the fourth and fifth cabinets from the ground. These QRPs should move easily, as the weight of
the array is being held by the front wheels of the Vertical Transporter resting on the ground.
• Raise the array and allow the four A8 cabinets to roll forward until the cart is resting safely on all four wheels. When the A8
cabinets on the VT reach this position, stop lifting the array. Remove the front QRPs and separate the suspended array from
the stack on the Vertical Transporter cart.
10.2 CLOSE THE ANGLE LOCKS AND MOVE PINS TO STORAGE
1
2
3
4
5
1
2
4
3
5
