6
Separate and strip the
ends of the speaker wire
as shown. Speakers and
electronics terminals have
corresponding (+) and (–)
terminals. Most manu-
facturers of speakers and
electronics, including JBL,
use red to denote the (+)
terminal and black for the
(–) terminal.
The (+) lead of the speaker
wire is noted with a stripe. It
is important to connect both
speakers identically: (+) on
the speaker to (+) on the
amplifier and (–) on the
speaker to (–) on the
amplifier. Wiring “out of
phase” results in thin sound,
weak bass and a poor
stereo image.
With the advent of
multichannel surround-
sound systems, connecting
all of the speakers in your
system with the correct
polarity remains equally
important in order to
preserve the proper
ambience and directionality
of the program material.
To connect the supplied
speaker wires to the satellite
and center speaker
terminals, press the red or
black plastic tab for the
desired terminal, insert the
bare end of the wire into the
hole and release the tab.
Gently tug on the wire to
make sure that it is fully
inserted.
To use the binding-post
speaker terminals on the
subwoofer, unscrew the
colored collar until the pass-
through hole in the center
post is visible under the
collar. Insert the bare end of
the wire through this hole;
then screw the collar down
until the connection is tight.
The hole in the center of
each collar is intended for
use with banana-type
connectors.
S P E A K E R C O N N E C T I O N S
Connection Tips
Downloaded from
www.Manualslib.com
manuals search engine
