3
Prepare the speaker wire as
described on Page 5. Thread
the two conductors through
the two holes in the stand
bracket. Make sure to pre-
serve the proper polarity
(+ and – connections) by
threading the positive con-
ductor through the hole on
the left, and the negative
conductor through the hole
on the right looking at the
stand from the front. Push
down on the red speaker
terminal and insert the bare
end of the positive wire into
the hole under the red cap.
Release the cap, and tug
gently on the wire to make
sure that the connection
is snug. Follow the same
procedure to connect the
negative wire to its terminal.
Use the larger screw
(Hardware Bag A) in the
upper screw hole, and the
smaller screw (Hardware
Bag A) in the lower screw
hole.
ATTACHING THE SHELF STAND TO THE SPEAKER
+
–
Gently pull the slack out of
the wire and screw the shelf
stand onto the back of the
speaker in two places, as
shown.
MOUNTING THE SATELLITES ON OPTIONAL FLOOR STANDS
Important Safety Note:
The
supplied floor stand adapters
facilitate installation with a
variety of general-purpose
floor stands available from
many manufacturers. Since
different stands will have
different weight capacities
and stability characteristics,
it is the customer’s responsi-
bility to check with the stand
manufacturer or dealer to deter-
mine whether that specific
stand is capable of handling
the weight and proportions
of these loudspeakers in a
safe and stable manner. JBL
disclaims any liability for the
selection of suitable floor
stands and/or correct
compatibility between the
selected stand and these
satellite loudspeakers.
The floor stand adapters are
compatible with floor stands
equipped with a 1/4"-20
threaded insert.
Prepare the speaker wire as
described on Page 5. Thread
the two conductors through
the two holes in the floor
stand adapter. Make sure to
preserve the proper polarity
(+ and – connections) by
threading the positive con-
ductor through the hole on
the left, and the negative
conductor through the hole
on the right (looking at the
front of the adapter). Push
down on the red speaker
terminal and insert the bare
end of the positive wire into
the hole under the red cap.
Release the cap, and tug
gently on the wire to make
sure that the connection
is snug. Follow the same
procedure to connect the
negative wire to its terminal.
Gently pull the slack out of
the wire and screw the adapter
onto the back of the speaker
in two places, as shown.
The floor stand adapter screws
may be found in Hardware
Bag B. Use the larger screw
in the upper screw hole, and
the smaller screw in the
lower screw hole.
Screw the floor stand
adapter into the floor stand’s
threaded insert until the
speaker is firmly attached to
the stand. Back off slightly
from the fully tightened
position until the speaker
is oriented as desired, then
rotate the thumbwheel at
the bottom of the floor stand
adapter to secure the
speaker to the stand.
+
–
SCS-SAT500,300,200 OM 4/25/07 11:39 AM Page 5
