EN-21
SA750 SPECIFICATIONS
Continuous power output (0.5% THD), per channel
Both channels, 8Ω, 20Hz—20kHz
130W
Both channels, 4Ω, at 1kHz
200W
Harmonic distortion, 80% power, 8Ω at
1kHz
0.002%
Analog Inputs
ADC
Texas Instruments PCM4202
Sample rate / bit depth
192kHz / 32 bit
Phono Inputs
Moving Magnet (MM)
Moving Coil (MC)
Input sensitivity at 1kHz (nominal)
5mV
0.35mV
Input impedance
47kΩ + 200pF
470Ω + 1nF
Signal/Noise ratio (A-wtd)
80dB, ref. 5mV at 1kHz 80dB, ref. 0.35mV at 1kHz
Overload margin
21dB ref. 5mV at 1kHz 21dB ref. 0.35mV at 1kHz
Frequency response (ref. RIAA curve)
20Hz – 20kHz ± 1dB
20Hz – 20kHz ± 1dB
Line Inputs:
Nominal sensitivity
1V
Input impedance
10kΩ
Maximum input
4.8Vrms
Frequency response
20Hz – 20kHz ± 0.2dB
Signal/Noise ratio (A-wtd) 100W, ref. 2.1V
input
112dB analog direct, 106dB ADC / DAC
Digital Inputs
DAC
ESS ESS9038K2M
Frequency response
20Hz - 20kHz ± 0.1dB
Total harmonics dist Noise
0.0007%
Signal/Noise ratio (A-wtd) ref. 0dBFS/100W 113dB
Supported sample
rates
Optical
32kHz, 44.1kHz, 48kHz, 88.2kHz, 96kHz
Coaxial
32kHz, 44.1kHz, 48kHz, 88.2kHz, 96kHz, 176.4kHz,
192kHz
Bit depth
16-bit – 32-bit
Pre-amplifier output
Nominal/Maximum output level
800mV / 1.25V
Output impedance
240Ω
Headphone output
Maximum output level into 600Ω
5Vrms
Output impedance
1Ω
Load range
16Ω – 2kΩ
General
Mains voltage
110–120V or 220–240V, 50/60Hz
Maximum power consumption
800W
Low power standby consumption
0.5W
Network standby consumption
2W
BTU rating
631 BTU
Dimensions W x H x D (including feet,
control knob and speaker terminals)
433x100x323mm
Weight (net)
10.7kg
Weight (gross)
13.8kg
Supplied accessories
Mains leads
Remote control
2 x AAA batteries
User Manual
Setup microphone
USB cable
All specification values are typical unless otherwise
stated. JBL has a policy of continuous improvement
for its products. This means that designs and
specifications are subject to change without notice.
E&OE.
