6. Press and hold the Setup button. The Setup indicators will flash one at
a time and you will hear brief test signals through your audio system’s
speakers. IMPORTANT: Do not move the MS-2 while the test signals
are playing.
7. Keep holding the Setup button until one of the three Setup indicators
remains lit, showing the setup results:
s/+3ETUPHASBEENCOMPLETEDSUCCESSFULLY
The MS-2’s DSP equalization and time
correction processing is now active.
s(IGH9OURVEHICLEAUDIOSYSTEMSVOLUME
control was set too high during the setup
procedure. Lower the system’s volume and
repeat steps 5 – 7.
s,OW9OURVEHICLEAUDIOSYSTEMSVOLUME
control was set too low during the setup
procedure. Raise the system’s volume and
repeat steps 5 – 7.
9OUCANREPEATTHESETUPPROCEDUREATANYTIME&OREXAMPLEIFYOUWANTTO
re-tune the system for a different listening position, simply repeat steps 5 – 7
while sitting in the new location. If you want to use the MS-2 in a different
vehicle, you will need to repeat the entire setup procedure (steps 1 – 7).
Setup Procedure:
1. Connect the MS-2 as shown in the
Connections
section on page 2.
2. Enable your vehicle audio system’s “Aux” (or MP3) input.
3. Set your portable audio player’s volume level to 3/4 full or higher and play
music on it. The MS-2’s input indicator should light green. If the input
indicator flashes red, turn the volume of your portable player down until
the red light stops flashing and remember the setting. This is the volume
control setting you should use on your portable player while using the MS-2.
4. Adjust your vehicle audio system’s volume control so the music is playing
at a comfortable volume level. Adjust the front/rear fader control so that
the sound comes mostly from the front speakers but so you can still hear
SOMESOUNDFROMTHEBACK9OUCANREADJUSTTHISAFTERSETUP
5. As you sit in your vehicle’s driver’s seat, hold the MS-2 directly in front of
your face, about 6 – 8 inches (150mm – 200mm) away.
Set player
volume at 3/4.
Input LED flashes.
6" – 8"
(150mm – 200mm)
DISTRACTION WARNING: Do NOT perform the setup procedure while
driving. We recommend that you perform these functions only after
pulling off the road into a position that you are absolutely sure presents
no risk. Always obey all traffic laws while driving.
4
Setup
LEDs
flash
Press-
and-hold
Setup
button
