13
Important notes
4
Prior to the final installation, carry out a sound check. If high distortion or intermittent
sound is experienced, it is possible that the wiring from the CD receiver to the boat's
electrical system is poor or that the battery needs recharging.
If the battery and its charging circuit are OK, then rewire the red fused wire of the CD
player directly to the positive terminal (+) of the boat battery.
Marine accessory shops stock the connector blocks and the 10 Amp cable which may
be necessary for extending the fuse wire connection.
Grounding
Make sure that the black wire on the wiring harness is connected to a good ground
point on the boat. If the chassis of the boat is used as a grounding point, make sure
that the surface is scraped clean from the metal before attaching the wire to it.
It is preferable to connect the black ground wire directly to negative terminal (-) of the
boat battery.
Warning: polarity...
This model is only suitable for use in boats which have a negative ground system,
e. g.. : the negative terminal of the boat
battery is connected to the chassis.
Connecting the speakers and power cables
Before you wire your system, disconnect your boats battery's positive (+) cable.
This helps prevent damage in case of a short. When you complete the wiring,
reconnect the battery cable and test your marine stereo. When connecting your
marine stereo's black ground wire, be sure to connect the wire to a metal part of your
boat or preferably to the negative (-) terminal of the boat battery.
POSITIVE
CHASSIS
NEGATIVE
CHASSIS
1. Reset Function
A microprocessor reset button has been provided to facilitate manual resetting of the
internal microprocessor. In the unlikely event that the player fails to operate correctly
refer to step 3 below.
Note:
It will be necessary to re-enter the radio preset memories as these will have
been erased when the microprocessor was reset. After resetting the player,
ensure all functions are operating correctly.
2. General Precautions
If the unit has become extremely hot we strongly recommend that you allow it to cool
down before using. Take care of your CD DISC to preserve the quality of the recording.
Do not allow CDs to be exposed to direct sunlight. Store them in a place protected
from dirt and dust and avoid handling them with oily, greasy or wet hands.
Be sure the CD is put into the CD slot label side up.
3. Caution
Precaution and Maintenance
2
1
1
2
3
3
RESET :
If you are faced with a malfunction during the operation, simply press
the reset button.
LED :
It flashes when the faceplate is removed.
CONNECTOR PIN :
Always keep connector pin clean.
If the PIN connector looks dirty, use cotton tips and clean it to avoid any
unexpected malfunction caused by dirt.
1
1
2
2
3
145x210mm
EST.JBL(MR4.2)-061129-I/B
