145x210mm
4
Important notes
Prior to the final installation, carry out a sound check. If high distortion or intermittent
sound is experienced, it is possible that the wiring from the CD receiver to the boat's
electrical system is poor or that the battery needs recharging.
If the battery and its charging circuit are OK, then rewire the yellow fused wire of the
CD player directly to the positive terminal (+) of the boat battery.
Marine accessory shops stock the connector blocks and the 10 Amp cable that may
be necessary for extending the fuse wire connection.
Grounding
Make sure that the black wire on the wiring harness is connected to a good ground
point on the boat. If the chassis of the boat is used as a grounding point, make sure
that the surface is scraped clean of paint before attaching the wire to it.
It is preferable to connect the black ground wire directly to negative terminal (-) of
the boat battery.
Warning: polarity...
This model is only suitable for use in boats which have a negative ground system,
e.g.: the
negative terminal of the boat
battery is connected to the chassis.
Connecting the Speakers and Power Cables
Before you wire your system, disconnect your boat battery's positive (+) cable.
This helps prevent damage in case of a short. When you complete the wiring,
reconnect the battery cable and test your marine stereo. When connecting your
marine stereo's black ground wire, be sure to connect the wire to a metal part of
your boat or preferably to the negative (-) terminal of the boat battery.
POSITIVE
CHASSIS
NEGATIVE
CHASSIS
9
1. Manual/Seek tuning buttons (4):
Press this button quickly to activate the Seek
mode. The Seek mode will automatically seek up or down the wave band and stop at
the next station of sufficient signal strength. Press and hold tuning buttons for 2
seconds to enter manual tuning mode. The unit will revert back to Seek mode after
10 seconds without use.
2. Manual Station store:
Select the desired band and tune to a radio station to be
memorized. Choose the preset button memory location1-6 into which the station is
to be stored and press and hold that preset button for 2 seconds.
The station will now be entered into the preset memory. 6 stations can be memorized
on each of the FM1, FM2, FM3, AM1, AM2.
3. A/PS - Auto store function (16)
Press and hold button (16) for approximately 2 seconds until you hear a beep to
confirm that the memory function is engaged. The unit will "SEARCH" for six strong
stations and automatically store them in buttons 1 - 6.
You can override the preset station for any button by manually setting a new frequency.
4. Scan (14)
In Radio mode, press the SCAN button (14) to scan strong stations for previewing.
At the desired station, press the SCAN (14) button again to stop scanning.
5. Program Memory Scan
Momentarily press A.PS (16) button to scan for stored stations.
Momentarily press it again to stop scanning.
Station Tuning
18
3
7
5
4
6
16
8
17
9
10
12
13
14
15
1
2
19
11
1
5
6
SEL
MODE
SH.SR
7.SCN
8.DISP
9.A/PS
0.LD
BD.FN
FLIP DOWN COMPACT DISC PLAYER
HI-POWER 4x52Watts
MR-32
MARINE
