6
COnneCTiOns
CAuTION: make sure that all of the system’s electrical components are turned OFF (and preferably
unplugged from their AC outlets) before making any connections.
Speakers and amplifiers have corresponding positive and negative (“+” and “–”) connectors. All LOFT series speakers
have connectors that are marked “+” and “–” on the terminal-cup assembly. Additionally, the “+” connectors have red
markings, while the “–” connectors have black markings.
To ensure proper polarity, connect each “+” connector on the back of the amplifier or receiver to the respective “+”
(red) connector on each speaker. Connect the “–” connectors in a similar way. Do not reverse polarities (i.e., “+” to “–”
or “–” to “+”) when making connections. Doing so will cause poor stereo imaging and diminished bass performance.
ImPORTANT: make sure the “+” and “–” wires or connectors do not touch each other or the other terminal.
Touching wires can cause a short circuit that can damage your receiver or amplifier.
The LOFT series speakers’ connectors can accept a variety of wire connector types: bare wire, pin connectors, spade
connectors and banana connectors.
uSING BARE WIRE OR PIN CONNECTORS:
1.
2.
3.
uSING SPADE CONNECTORS:
1.
2.
3.
uSING BANANA CONNECTORS:
1.
2.
Connect the amplifier to each speaker as shown in the illustration below.
+ –
Receiver or Amplifier
(One Channel Shown)
Speaker
Connector Panel
