36
41
28
22
16
2
11
32
21
3
7
29
34
14
13
12
25
39
35
8
33
10
26
19
6
40
9
38
31
20
23
17
5
4
18
35
37
1
30
35
24
15
27
EXPLODED VIEW
K2 S9800/K2 S9800SE
Rev 1 5/07
Harman Consumer Group, Inc., 250 Crossways Park Drive, Woodbury, New York 11797
Technical Manual
K2 S9800/K2 S9800SE
TO SERVICE THE K2 S9800/KS 9800SE
The crossover network, after removal of the (6) faceplate screws,
should extract far enough out of the cabinet for service without wire or
driver removal.
Access to 9V bias batteries – metal plate removed by two thumb-
screws on the network faceplate.
Replacement or service of the high-frequency drivers requires access
through the woofer opening, following these steps:
NOTE: IT IS RECOMMENDED THAT TWO PERSONS BE INVOLVED
IN K2 S9800/K2 S9800SE DISASSEMBLY.
1) Lay the loudspeaker down on its back (drivers facing up), on a
padded surface.
2) Remove the grille.
3) Remove the (8) Phillips woofer screws.
4) The woofer is best extracted by inserting two 1/4 x 20 (3" or longer)
threaded machine screws into opposite sides of the two threaded
woofer screw openings. Caution: Only two of the holes are threaded;
they should be the top and bottom holes in the woofer frame. Thread
the bolts into the openings by hand, then pull upwards, lifting the
woofer from the counterbore. Then, while one person supports the
woofer, another can remove both connecting wires from the terminals.
Set the woofer aside.
5) Inside the cabinet, at the bottom of the HF horn, are the three
mounting screws; remove them.
6) The HF horn can now be removed from the cabinet by reaching in
and pushing the assembly out; remove both connecting wires from the
terminals. Set the HF assembly/horn aside.
7) The (10) screws holding the top cap assembly are now exposed;
remove them.
8) Lift the top cap assembly with UHF assembly off the cabinet.
NOTE:
a) When replacing the HF horn, to assist the (3) screwholes in lining
up properly, one person may have to depress the gasket by pressing
the horn assembly down into the cabinet, while the other replaces
the screws.
b) Observe correct polarity when reattaching all driver wires.
#16 Not
used in later
versions
Note: This panel is not
removable from the
front on later versions;
it is attached from the
rear with screws.
