JBL HTPS-400, Service Manual, Page: 22 / 32

HTPS-400 SUBWOOFER
22
HS0065 13 SCREW, #6-32X1/4 PAN PHIL BLK 1PC
USED WITH MM0025 ;8PC USED WITH
STANDOFF WITH POWER SUPPLY BD;
4PC USED WITH 1.5 STANDOFF;
HS0067 4 SCREW, #6-3/8 TYPE A PP BLK USED
ON THE STANDOFF
HS0079 1 SCREW, #6-32X1.25 FL SLOT NYL
USED WITH THE CHOKE;
HTPS400 PANEL 1 HTPS400 PANEL COMPLETE
HW0030 4 WASHER, FLAT #8 NYLON FOR LINEAR
BOARD MOUNTING
JC0071 1 CNCTR, FEM-FEM HARNESS 8PIN 9
FROM FEATURE BOARD TO LINEAR
BOARD
JC0076 1 CNCTR, AC IEC SOCKET .250TAB
JC0088 1 CNCTR, FEM-LED R/G 30 2PIN LED
HARNESS
JC0134 1 CNCTR, FEM-FEM HARNESS 5PIN 9
FROM POWER SUPPLY BOARD TO
LINEAR BOARD
JC0158 1 CNCTR, FEM-FEM HARN 5P 18 SHI
FROM FEATURE BOARD TO EMI
BOARD
MC0001 4 CABLE, TIE 4 NATURAL
MC0003 2 CABLE, TIE 40MM W/ METAL RING TIE
HARNESS JC0158 TO LINEAR HEAT
SINK
MM0030 2 MISC, FOAM .5X.5X.25 HOLE USED
WITH THE TOGGLE SWITCHES
MM0040 1 MISC, FOAM GASKET FOR JC0049
USED WITH THE DUAL RCA
MM0061 2 MISC, WIRE CLAMP NYLON TO BIND
WIRES;
MS0005 11 SILPAD, .009 .3C/W TO3P
MS0014 1 MISC, CERAMIC PLATE TO-220
MZ0003 4 STANDOFF, 6-32 3/8 ROUND AL USED
TO MOUNT POWER SUPPLY TO PANEL
MZ0031 4 STANDOFF, 3/8 NYLON LOCKING 4PC
USED ON THE EMI BOARD
MZ0041 4 STANDOFF, #6 1.5 HEX FEM-MALE
STANDOFF SHOULD BE POSITIONED
SO THAT THE FEMALE END IS IN CON-
TACT WITH THE PCB AND THE MALE
SIDE GOES THROUGH THE HEATSINK;
RC0147 1 RES, CF 6M8 1/4W 5% CONNECTED
FROM U4 PIN4 TO NEGATIVE TERMI-
NAL OF C20 WHICH IS LOCATED AT
THE LOWER END OF U4;
RP0058 2 POT, KNOB CR00-15MB-16H
TS0018 2 FIBREGLASS, HT210 #2AWG 10 TO
SHIELD WIRES
Electrical Parts List
Part Reference Quantity Description
No. Designator