22
Power light is on, but no sound is heard
• Defective head unit or signal processor;
from some or all of the speakers
check each component for proper wiring
and operation.
• Defective GTH400; If there is audio
signal present at the inputs of the
amplifier and there is no output, the
GTH400 may be defective.
Alternator whine through the audio system • Ground loops; follow the wiring
with the engine running
suggestions in the section called
“Solving Noise Problems.” Also, verify
that the chassis grounding point you
have chosen is true ground by checking
for continuity between the chassis
ground point and battery ground.
Bass output from speakers too low
• Speaker wired out of phase; check for
proper polarity on all speaker wiring
(+ amp terminal to + speaker terminal
and – amp terminal to – speaker
terminal).
Amplifier Power Light is on and
• Verify that the remote control is not set
sound is heard from the front and rear
in “BYPASS” mode by checking to see
channels but the Imaging is not improved
that the “ON” LED is lit.
with the image enhancer on
• Using the system configuration diagram,
confirm that the audio connections are
correct for signal path and polarity. Note
that right hand drive car installations
must have the Left and Right input and
output connections reversed as shown in
the wiring section on page 19.
• Perform the adjustments as directed in
the Imaging Enhancer Setup section.
Power light is blinking and
• Incorrectly connected or shorted speaker
no sound is heard
wires; check for shorts in wiring.
• Defective GTH400; if there is no short
on the speaker outputs, the GTH400
may be broken. Consult your JBL dealer.
GTH400-20107 06/03/98 15:50 Side 22
