background image

MANUFACTURER’S RECOMMENDATIONS 

Load

– Do not exceed the Safe Working Load (SWL) of the 

Gripple.   The SWL of the Gripple product included with this 
loudspeaker is 45 kg (100 lbs). 

No lifting 

– Do not use for lifting, such as in a crane or pulley 

situation.

No movement 

– Gripple hangers are to be used to suspend 

static loads only. Do not use to suspend moving services, or 
services likely to be subject to movement.   

No joining 

– Gripple hangers must not be spliced together  

using a Gripple fastener, or any other joining device. A Gripple 
hanger assembly must comprise one length of cable and one 
Gripple fastener only. If a longer length is needed, do not 
attempt to join two assemblies together. 

Limitations of use 

– All Gripple hangers, accessories, and 

other Gripple products must only  be used for suspending items 
recommended by the manufacturer. 

Painting

– If painting, ensure that a Gripple Décor Cover is  

applied to the Gripple fastener before painting to protect from 
the ingress of paint.   Do not move the Gripple fastener on the 
cable after painting. 

Building codes 

– Compliance with local codes, and where  

applicable national codes, is the buyer and/or installers  
responsibility. 

Not for re-use 

– Gripple hangers are designed for permanent  

installations, not for re-use. 

Lubricants

– Do not apply oil or any other lubricant to any part 

of the assembly. 

Not for seismic bracing 

– For Gripple products that have been 

tested and approved for seismic restraint applications, please 
refer to the Gripple Seismic product line. 

Round duct/pipes 

– When wrapping around duct or other round 

pipes, do not exceed an angle of 60 degrees between the top of 
the pipe and the Gripple.  

Environment

– Standard Gripple hangers may be used only in 

dry locations. Stainless steel Gripple hangers may be used in 
certain indoor corrosive environments such as properly  
ventilated swimming pool arenas. 

Failure to observe these usage instructions may result in  
product malfunction, resulting in property damage and bodily  
injury. At time of shipment Gripple products are warranted to 
conform to the manufacturer's published specifications and to  
be free from defects in material and workmanship. No other  
warranty, whether expressed or implied, including any
warranty of merchantability or fitness for purpose, whether  
expressed or implied, shall exist in connection with the sale or 
use of any Gripple product.

C60 INST INSTR   08/10

For further technical assistance in the use of this Gripple suspension  product, please contact: 

Gripple Inc.  1611 Emily Lane  Aurora,  IL 60502  1-630-406-0600    www.gripple.com 

JBL Professional 

8500 Balboa Blvd 

Northridge, CA 91329 

USA 

See Other Side for Speaker Installation Instructions

Summary of Contents for Control 67 P/T

Page 1: ...nectors and an optional terminal cover is available for harsher locations Specifications System Frequency Response 10 dB 1 58 Hz 18 kHz Frequency Range 3 dB 1 78 Hz 16 kHz Power Capacity2 75 Watts Continuous Pink Noise Power with 300 Watts peaks 150 Watts Continuous Program Power Nominal Sensitivity 90 dB Nominal Coverage Angle3 120 20 15 Directivity Q 3 5 7 Directivity Index DI 3 7 5 dB Rated Maxi...

Page 2: ...frequency Frequency Response Full space 8 ohm 10 off axis typical for coverage area Dimensions Off Axis Frequency Response 312 12 3 350 13 8 330 13 0 Dimensions in mm in JBL Professional 8500 Balboa Boulevard P O Box 2200 Northridge California 91329 U S A Copyright 2010 JBL Professional www jblpro com ...

Page 3: ...ires with trimmer suitable for 2 mm 0 077 in diameter stranded aircraft type cable SPEAKER INSTALLATION INSTRUCTIONS using Suspension Systems 3 With speaker supported snap main support hook hanger onto the center hole in the top bracket of the speaker Adjust to proper height by pulling cable through either end of Gripple Detail 3 3 Adjust height Detail Fittings are suitable for use in Air Handling...

Page 4: ...lations not for re use Lubricants Do not apply oil or any other lubricant to any part of the assembly Not for seismic bracing For Gripple products that have been tested and approved for seismic restraint applications please refer to the Gripple Seismic product line Round duct pipes When wrapping around duct or other round pipes do not exceed an angle of 60 degrees between the top of the pipe and t...

Reviews: