www.jbl.com
•
Do not place objects on top of the speaker.
•
Wipe the cabinet with a clean, dry cloth to remove dust. Damp cloths may dull the cabinet finish. Do not use volatile
liquids or solvents such as benzene, paint thinner or alcohol on the cabinet.
•
Do not spray chemicals near the cabinet.
•
To remove dust from the grille fabric, use a vacuum cleaner set to “low” suction.
•
Do not wash the grilles in water, as it may fade the color or make them uneven.
•
If the woofer cones become dusty, you can carefully sweep them clean with a soft, dry
calligraphy brush or paint brush. Do not use a damp cloth.
•
NEVER touch the tweeter dome or put anything against it.
CARING FOR YOUR SPEAKERS
5
CAUTION: Make sure that all of the system’s electrical components are turned OFF (and preferably unplugged
Speakers and amplifiers have corresponding positive and negative (“+” and “–”) connection terminals. All Arena series
speakers have connection terminals that are marked “+” and “–” on the terminal-cup assembly. Additionally, the “+” terminals
have red markings, while the “–” terminals have black markings.
To ensure proper polarity, connect each “+” terminal on the back of the amplifier or receiver to the respective “+” (red) terminal
on each speaker. Connect the “–” terminals in a similar way. Do not reverse polarities (i.e., “+” to “–” or “–” to “+”) when making
connections. Doing so will cause poor stereo imaging and diminished bass performance.
Touching wires can cause a short circuit that can damage your receiver or amplifier.
Connect the amplifier to each speaker as shown in the illustration below.
CONNECTIONS
Receiver or Amplifier
(One Channel Shown)
Speaker
Connector Panel
© 2014 Harman International Industries, Incorporated. All rights reserved.
Features, specifications and appearance are subject to change without notice.
TR00052_A
Harman International, Inc.
8500 Balboa Boulevard, Northridge, CA 91329 USA
www.jbl.com
from their AC outlets) before making any connections.
IMPORTANT : Make sure the (+) and (–) wires or connectors do not touch each other or the other terminal.
BASIC SINGLE-WIRE CONNECTION
