JBL 300 Series Quick Start Manual Download Page 8

SPECIFICATIONS

CINEMA 300 SYSTEM

Frequency response:

32Hz – 20kHz (–6dB)

CINEMA 300 CENTER SPEAKER

Low-frequency transducer:

Two 3" (75mm) PolyPlas cones, 
video-shielded

High-frequency transducer:

1" (25mm) titanium-laminate dome,  
video-shielded

Recommended power handling:

100 watts

Nominal impedance:

8 ohms

Sensitivity (2.83V/1m):

89dB

Crossover frequency:

3.7kHz

Enclosure type:

Sealed

Connector type:

Push-spring terminal

Dimensions (H x W x D):

4-7/8" x 12" x 3-3/8"  
(124mm x 305mm x 86mm)

Weight:

3.2 lb (1.45kg)

CINEMA 300 SATELLITE SPEAKERS

Low-frequency transducer:

3" (75mm) PolyPlas

 cone, video-shielded

High-frequency transducer:

1" (25mm) titanium-laminate dome,  
video-shielded

Recommended amplifier power:

100 watts

Nominal impedance:

8 ohms

Sensitivity (2.83V/1m):

86dB

Crossover frequency:

3.7kHz

Enclosure type:

Sealed

Connector type:

Push-spring terminal

Dimensions (H x W x D):

9-1/4" x 4-3/4" x 3-3/8"  
(235mm x 121mm x 86mm)

Weight:

2.0 lb (0.9kg)

SUB140P SUBWOOFER

Low-frequency transducer:

8" (200mm) cone (down-firing)

Enclosure type:

Ported (down-firing)

Amplifier power:

150 watts

Frequency response:

32Hz – 150Hz (–6dB)

Audio controls:

Volume level, phase, crossover frequency

Connections:

LFE input, left and right RCA line-level 
inputs

Power requirement:

120V/60Hz, 150W (US);  
220V – 240V/50Hz, 150W (EU)

Power consumption:

<1W (8mA@120V) standby;  
300w (2.5A@120V) peak

Dimensions (W x H x D):

19" x 14" x 14"  
(483mm x 355mm x 355mm)

Weight:

22 lb (10kg)

HARMAN Consumer, Inc.
8500 Balboa Boulevard, Northridge, CA 91329 USA

© 2010 HARMAN International Industries, Incorporated. All rights reserved. 
JBL is a trademark of HARMAN International Industries, Incorporated, registered in the United States 
and/or other countries. PolyPlas is a trademark of HARMAN International Industries, Incorporated.
Features, specifications and appearance are subject to change without notice.

Part No. 950-0297-001  Rev. A

www.jbl.com

Summary of Contents for 300 Series









Reviews: