HANDLING PRECAUTIONS
Never attempt to move a full or partially full Nano-Cube.
Never lift by grabbing the aquarium frame
Never use cleaners that contain ammonia to clean the glass surfaces.
Always lift and carry the Nano-Cube from underneath
giving support to the bottom at all times.
CHOOSING A LOCATION
A. With a Nano-Cube Stand
1. Find a leveled surface and place Nano-Cube on top of
stand before filling with water. Make sure that no part of the tank
is overhanging the stand.
B. Without a Nano-Cube Stand
1. Find a leveled surface that can support the weight of
the tank, water, and livestock. An average aquarium can weigh
10lbs per gallon once filled with water, rock, gravel, and other
accessories.
2. Do not place in direct sunlight to prevent excessive
algae growth and higher water temperatures.
FILLING THE TANK
Always dechlorinate tap water before adding into the aquarium.
Always fill with room temperature water.
Rinse Activated Carbon which is located in the rear filter compartment
under the sink for 30 seconds or until water runs
clear.
Fill the main body of the Nano-Cube until water flows through
intake grill into the rear filter chamber. Once the rear filter chamber
is full, plug in pump power cord into an approved electrical
outlet with a fuse or circuit breaker.
Once pump is on, water will flow from the rear filter chamber
through the directional flow nozzle into the main body of the
Nano-Cube. Adjust accordingly to desired flow position.
ADDING THE MODULAR SURFACE SKIMMER
Unpack the Modular Surface Skimmer (Included) and place in
front of intake grill once pump has been turned on.
The Modular Surface Skimmer will instantly attach and start to
surface skim all surface film and floating particles from the water.
This device should be removed when changing water or be- fore
turning off the pump
Note: Evaporation will occur in the rear filter chamber when
using the Modular Surface Skimmer. Water top offs should be
performed regularly to prevent the heater and pump from
running dry.
15
16
