JBJ 28g Nano Cube LED, Owner'S Manual, Page: 12 / 22

HANDLING PRECAUTIONS
Never attempt to move a full or partially full Nano-Cube.
Never lift by grabbing the aquarium frame
Never use cleaners that contain ammonia to clean the glass sur-
faces. Always lift and carry the Nano-Cube from underneath
giving support to the bottom at all times.
CHOOSING A LOCATION
A. With a Nano-Cube Stand
1. Find a leveled surface and place Nano-Cube on top of
stand before filling with water. Make sure that no part of the
tank is overhanging the stand.
B. Without a Nano-Cube Stand
1. Find a leveled surface that can support the weight of
the tank, water, and livestock. An average aquarium can weigh
10lbs per gallon once filled with water, rock, gravel, and other
accessories.
2. Do not place in direct sunlight to prevent excessive
algae growth and higher water temperatures.
FILLING THE TANK
Always dechlorinate tap water before adding into the aquar-
ium. Always fill with room temperature water.
Rinse Activated Carbon which is located in the rear filter com-
partment under the sink for 30 seconds or until water runs
clear.
Fill the main body of the Nano-Cube until water flows through
the overflow grill into the rear filter chamber. Once the rear filter
chamber is full, plug pumps into the Ocean Pulse Wavemaker.
Adjust the dial on the wavemaker to create the alternating ON/
OFF cycles for the pumps. Plug the wavemaker power cord into
an approved electrical outlet with a fuse or circuit breaker.
Once pumps are on, water will flow from the rear filter cham-
ber through the directional flow nozzles into the main body of
the Nano-Cube. Adjust accordingly to desired flow position.
12