jbc KN-A, Instruction Manual

Page: 5 / 12

Main menu
Exit
1 Reset settings
2 Station settings
3 Tool settings
Station settings
1 Temp unit Celsius
2 Maximum temp 400
0
C
3 Minimum temp 200
0
C
4 Nitrogen mode ON
www.jbctools.com
5
Once the Nitrogen Flow Regulator (MN-A) is connected to the Control Unit, enter the Station Settings
menu and enable the Nitrogen Mode.
The MN is an electrovalve controlled by the soldering station that allows you to solder using nitrogen.
It guarantees minimal gas consumption and prevents tip oxidation.
The nitrogen flow is automatically activated when the soldering iron is lifted from the stand.
It stops when the tool is placed back and the tip temperature drops to the sleep mode.
Recommended N
2
flow:
1-2 SLPM
N
2
flow control
Initial Set up
Operation