![background image](http://html1.mh-extra.com/html/jbc/cp-qf/cp-qf_instruction-manual_3745019015.webp)
Safety
- Do not use the units for any purpose other than soldering or rework. Incorrect use may cause fire.
- The power cord must be plugged into approved bases. Be sure that it is properly grounded
before use. When unplugging it, hold the plug, not the wire.
- Do not work on electrically live parts.
- The tool should be placed in the stand when not in use in order to activate the sleep mode.
The soldering tip, the metal part of the tool and the stand may still be hot even when the station
is turned off. Handle with care, including when adjusting the stand position.
- Do not leave the appliance unattended when it is on.
- Do not cover the ventilation grills. Heat can cause inflamable products to ignite.
- Avoid flux coming into contact with skin or eyes to prevent irritation.
- Be careful with the fumes produced when soldering.
- Keep your workplace clean and tidy. Wear appropriate protection glasses and gloves when
working to avoid personal harm.
- Utmost care must be taken with liquid tin waste which can cause burns.
- This appliance can be used by children over the age of eight and also persons with reduced
physical, sensory or mental capabilities or lack of experience provided that they have been given
adequate supervision or instruction concerning use of the appliance and understand the hazards
involved. Children must not play with the appliance.
- Maintenance must not be carried out by children unless supervised.
It is imperative to follow safety guidelines to prevent electric
shock, injury, fire or explosion.
OK
TOOL
EAR
THING FUSE
AUX
USE ONL
Y
WITH A 250
V FUSE
OK
TOOL
EAR
THING FUSE
AUX
USE ONL
Y
WITH A 250
V FUSE
OK
TOOL
EAR
THING FUSE
AUX
USE ONL
Y
WITH A 250
V FUSE
Fuse
holder
Before carrying out maintenance, always allow the equipment to cool.
- Clean the station screen with a glass
cleaner or a damp cloth.
- Use a damp cloth to clean the casing and
the tool. Alcohol can only be used to clean
the metal parts.
- Periodically check that the metal parts
of the tool and stand are clean so that the
station can detect the tool status.
- Maintain tip surface clean and tinned prior
to storage in order to avoid tip oxidation.
Rusty and dirty surfaces reduce heat transfer
to the solder joint.
- Periodically check all cables and tubes.
- Replace any defective or damaged pieces.
Only use original JBC spare parts.
- Replace a blown fuse as follows:
1. Pull off the fuse holder and remove the
fuse. If necessary use a tool to lever it off.
2. Insert the new fuse into the fuse holder
and return it to the station.
Maintenance
- When this warning appears on the
main screen Earthing Fuse must be replaced
- Repairs should only be performed by a JBC authorized technical service.
Clean
periodically
EARTH
FUSE
www.jbctools.com
15
Summary of Contents for CP-QF
Page 1: ...Compact Micro Tweezers Station Ref CP QF INSTRUCTION MANUAL www jbctools com...
Page 16: ...Notes 16...
Page 17: ...Notes www jbctools com 17...
Page 18: ...Notes 18...