10
MAINTENANCE
Prior to maintenance or storage should
disconnect the equipment from the power supply
and let it cool down.
- Use a damp cloth to clean the case and the
tool. Alcohol can be used only to clean the
metal parts.
- Check periodically that the metal parts of the
tool/stand are clean in order to have a good
detection when the tool is in the stand.
- Clean the station’s screen with a glass cleaner
Remove the fuse by pulling the black cap. Help
yourself with a lever tool if necessary.
Place the new fuse into the holder by pushing
and enter it again into the station.
Clean periodically
or a damp cloth.
- Maintain tip surface clean and tinned prior to storage in order to avoid tip oxidation.
Rusty and dirty surfaces reduce heat transfer to the solder joint.
- Periodically check all cables and tubes connected.
- Replace any defective or damaged handpiece or tool.
- Replace the fuse if it is blown according to the following guidelines:
REPAIR
- Repairs should be performed only by a specialist. Otherwise JBC can not rule out the risk of accident.
- JBC offers you a professional after-sales service for your equipment.
CF /
SOLDER FEED STATION
