jbc CDES, Instruction Manual

Page: 11 / 24

CD-Q:
OK
CD-Q:
OK
CD-Q:
OK
Changing the Grips
Put the slide-on tabs into the
new grip. Hold the grip and pull the tab.
Use pliers if necessary.
tabs
new grip
Replace the grips easily using the slip-on tabs.
Note:
Choose the correct grip depending on your handle
model.
1. Inserting Tabs 2. Inserting Handle 3. Removing Tabs
The sealing plug prevents undesirable flux vapors or particles from entering inside the tool. Its usage
is highly recommended for intensive applications when soldering is exposed to FOD environments or
for applications where the soldering iron works close to vertical position.
Note:
Choose the correct
sealing plug depending on your handle model.
Sealing Plug Replacement
Before replacing the sealing plug, unplug the power supply and make sure the device is not hot.
Note:
The chamfered side has
to be positioned towards the
handle.
2. Mounting Position 3. Inserting Sealing Plug 1. Removing Sealing Plug
Sealing
Plug
Handle
Push the sealing plug inside
the handle until the sealing
plug and handle edges are
aligned. Enter, not deeper than 8mm,
a small shaft or screwdriver,
lift and pull the sealing plug.
Never use a cartridge to do
this operation.
Handle ref.:
T245-A / T245-C / T245-GA T210-A / T210-NA T245-PA T210-PA
Grip ref.:
0016057 (green) 0018658 (green) 0021528 (blue) 0023310 (blue)
Handle ref:
T245 / T470 T210
Sealing plug ref.:
OB2000 OB1000
Push the grip with the tabs
onto the handle.
www.jbctools.com
11