![background image](http://html.mh-extra.com/html/jbc/al-1a/al-1a_reference-manual_636975006.webp)
5
Guide tube screw
Guide tube
8 - 10 mm
4
. Place the solder feed handpiece.
¡Warning!
As a safety measure and in order to avoid burns,
when the cartridge is manipulated you must switch off
the station or disconnect the solder feed handpiece.
Take into account that it only takes a few seconds to
reach the working temperature.
4
ENGLISH
7
. Take the solder thread from the solder reel until
the guide tube start.
Place the control in the indicated position in order
to close the dragging mechanism.
5
. Place the guide tube for the solder threat in the
solder feed handpiece. You must leave a distance
between 8-10mm from the tip of the cartridge and
the end of the guide tube end. Tighten the screw of
the guide tube.
6
. Point the tip of the cartridge to the solder guide
tube exit. Tighten the cartridge screws.
7
7
Connect the handpiece to the station and switch
it on. Press the WIRE LOAD key (Fast dragging
thread) till the solder leaves by the end of the guide
tube. Display will show the message "LOADING
SOLDER WIRE".
Thread dragging
button
Important.
- It is essential to insert the cartridge till the
end for a good connection. Take the mark
as reference.
Fast dragging thread
Alignment
6
C a r t r i d g e a n d
electric connection
screw
4
WARNING: It is esential
to tighten this screw for
the tool to function.
Summary of Contents for AL-1A
