JB-Lighting SPARX 10, Operating Instructions Manual

Page: 41 / 72

- 41 -
10
Connection non EU-model:
The Sparx10 may only be connected to mains supply systems according to this drawing:
mains
Sparx10
2 conductor
1 phase L
N L
N
PE
3 conductor
1 phase L
N
L L
PE
N
4 conductor
3 phase L
1
L
2
L
3
N
L
N
PE
WARNING: only can be used in
Canadian mains supply system
with 2 conductor, 1 phase with
max. 120V!
ATTENTION: Le A8 peut être uti-
lisé au Canada avec 2 conduc-
teurs, 1 phase et une tension
maximal de 120V!
!
3.2 Rigging the fixture
WARNING: Keep fixtures at least 1,0 meter away from inflammable articles! Always
use a safety cable attached to the base!
ATTENTION: Respecter une distance minimale de 1,0 m entre le projecteur est
d‘éventuelles objets inflammables! Sécuriser toujours le Sparx10 avec une élingue
de sécurité appropriée!
!
The Sparx10 can either be placed on the floor or hang on
a trussing system in any position. When placing the unit
on the floor make sure that it stands on rigid ground, be-
cause the air inlets in the base must not be covered with
anything! To mount the unit on a trussing system use two
of the original JB-Lighting omega brackets with Cam-
loc-connectors. The Camlocs must snap in to be locked
properly. Always attach a safety cable to secure the unit.
The Sparx10 is supplied with a power cable with a Neutrik PowerCon connector. Install a 3-prong
grounding type plug that fits your supply. US model comes without power cable and connectors.
Required cable type see 4.5. Connected load: voltage 100-240 V, frequency 50 - 60 Hz
Connection EU-model:
Color Function Symbol
brown Live „L“
blue Neutral „N“
green/yellow Ground
140
224
140