PVB-9500
Jaypro Carbon Ultralite 3” O
D Net System Instructions
- 2 of 9-
UPDATED 12/12/2018
1
Safety
•
WARNING
:
Do not attempt to remove the height adjuster pin if the net is under
tension.
•
WARNING: Always use protective padding around each upright during use.
•
IMPORTANT: Follow all warning labels on equipment.
•
IMPORTANT: Inspect for damage before and after each use.
2
Specifications
O
UTER
D
IAMETER
H
EIGHT
R
ANGE
#
OF
P
OSITIONS
W
EIGHT
U
PRIGHT
M
ATERIAL
PVB-9500
3
”
(76mm)
6’6” to 8’2” ± 1.5”*
(2.0m to 2.5m± 4cm)
8
Pin Stops
34 lbs
(13kg)
Carbon Composite
*Greater adjustability can be ordered upon request to accommodate deeper floor sleeves
3
Introduction
Note: The Flex Net supplied with this system will stretch slightly during the first few uses.
This is a natural consequence of the headband fibers being stretched under tension.
During this break-in period, the headband and net body may sag during use. Simply
increase tension (center if necessary) to remove the sag.
These instructions assume that the appropriate ground sleeves have been correctly
installed:
•
The inside bottom surface of the ground sleeves must be 10” below ground level
•
The PVB 9500
standards will fit most 3” inner diameter ground sleeves
.
•
The bottom 10 inches of the standards have been covered with an outer layer to
improve fit in most ground sleeves. If fit is too tight, cut outer layer with knife and
remove.
•
The Flex-
Net will work with ground sleeves spaced 35’ to 37’ apart on center
1
.
1
NCAA and NFHS rules require that the upright standards must be installed at least 3’3”
(1m) outside the court boundaries. Jaypro recommends 36’ spacing on center to satisfy
both regulations.
