Page
6
of
6
Assembly Instructions:
13.
Attach the loop on one end of the bottom cord to the S-hook on one of the bottom
sliding collars. Thread the other end through the Clam Cleat fitting, as shown. Pull
the free end of the cord to draw the bottom cord taunt. Next, tie off the six (6) side
cords around the uprights, making sure the net is approximately centered within the
playing area.
14.
Raise the center of the net to the full official net height by cranking the handle. Adjust all
net side cords to further tension the net.
15.
When releasing tension on the net, first untie the side cords and release tension on the
bottom cord, and then slowly release tension of the top cable.
16.
To remove the unit for storage, disconnect the net from the 2 uprights and carefully lift
each upright from the floor sleeve.
17.
For player safety cut any excess chain before putting system into service.
INSTALLATION AND USE CONSIDERATIONS
1) The unit is designed for high level competition play. Consequently, when installed
and operational, the unit is subject to considerable stress loads. It is essential to inspect
all parts before each use.
2) Do not use this equipment without the protective upright padding properly fastened in place.
Tennis:
Badminton:
VELCRO STRAPS
VOLLEYBALL
ANTENNA
NET DOWELS
(BOTH ENDS)
NOTE: SAG, ADJUST BY PLACING
THE TOP
COLLARS ¾” HIGHT
THAN DESIRED NET HEIGHT.
Volleyball:
7’ 11 5/8” (2.43 m) Men’s
7’ 4 1/8” (2.24 m) Women’s
5’
(1.52 m)
3’-6”
(1.07 m)
