4
Required For This Page:
•
HEX HEAD BOLT APPROXIMATELY 6” - 7” LONG WITH
WASHERS, LOCK WASHERS AND HEX NUT. (SET OF 6)
•
BACK POST PLATE
•
EXTENSION ARM WELDMENT
•
HEX HEAD BOLT APPROXIMATELY 3” LONG WITH
WASHERS, LOCK WASHERS AND TWO HEX NUT. (SET OF 4)
!
!
WARNING
*BECAUSE OF THE SIZE AND WEIGHT OF THE SYSTEM, A MINIMUM OF
THREE ADULTS ARE REQUIRED FOR THE FOLLOWING STEPS*
a.
Assemble the 5 inch by 5 inch hole pattern backboard to extension arm weldment 5 inch by 5 inch hole pattern.
b.
Using the 4 sets of hex head bolt that fits the 5 inch by 5 inch hole pattern. Order of main part is rim, gasket,
backboard and extension arm weldment, tie four items using the hex head bolt with washer thru rim and gasket.
Into the backboard nut in the 5 inch by 5 inch hole pattern, use a hex nut to hold the rim and gasket to the
backboard. Then lift the backboard on to the extension arm weldment 5 inch by 5 inch hole pattern. Finish this
off with washers, lock washers and hex next, repeat till all four set of hardware is securely on ( see figure 1&2).
STEP 1
a.
Position the extension arm and back post plate to the post near the white
stripe.
b.
Using the longest hex head bolt to tie the two item mention above using
the hardware as shown below. DO NOT OVER TIGHTEN!
c.
Set the top holes in the plate to 119 inch to the playing surface.
STEP 2
119” TOP HOLES TO PLAYING SURFACE
